Spray foam insulation: worth the investment, or a mortgage risk?

The short answer
Spray foam insulation genuinely insulates. That is not in question. What is in question is whether it is worth what it can cost you later, at the point you come to sell or remortgage, and for most lofts, the answer is no, not when a far lower-risk alternative does a similar job.
This is not a typical “it depends on your home” post. The caution here applies to almost everyone considering it.
Why people consider it
Spray foam is applied wet and expands to fill gaps that rigid or roll insulation cannot easily reach, awkward roof shapes, junctions, and small voids. Installed well, in the right roof, it insulates effectively and can be quicker to fit than a full re-roof or a rigid-board retrofit.
That genuine case is exactly why it has been sold hard, including, on RICS’s own account, through “poor standards of work, illegal modifications to listed buildings and high-pressure selling to vulnerable groups.”
Open-cell or closed-cell, and why it does not solve the problem
If you research this at all, you will see open-cell and closed-cell foam presented as a meaningful choice, sometimes with one pitched as the “safe” option. It is worth understanding the real difference, and why it does not change the core risk this post is about.
- Open-cell foam is soft, sponge-like, and breathable, expanding significantly as it is applied. Being breathable cuts both ways: it lets moisture pass rather than trapping it in one place, but it can also absorb water if a roof leak reaches it, which then sits against the timber it is covering.
- Closed-cell foam is dense, rigid, and forms a near-complete vapour barrier. That barrier stops moisture getting in from outside, but it also stops any moisture already in the timber, or that later finds a way in, from drying out, which is exactly the mechanism behind the trapped-damp, hidden-rot cases surveyors are trained to flag.
Removal reflects the same distinction: open-cell can usually be cut and pulled away, reported at roughly £4,000 to £8,000 for a typical job; closed-cell’s rigid, adhered structure is harder to remove, reported at roughly £6,000 to £12,000 or more.
The reason this does not solve the underlying problem: UK lenders and insurers generally do not distinguish between the two types in their policies. Both obscure the roof timbers from a survey, and both are, in practice, treated as spray foam, full stop, when a mortgage application or insurance quote is assessed. Choosing “the better one” does not remove you from the lending and insurance risk described below.
The caveat that actually matters
This is the part worth reading slowly before you agree to anything.
Roof timbers become invisible to a survey. Once foam is sprayed directly onto the underside of a roof, a surveyor can no longer see the timbers to check for rot, damp, or existing defects, the entire point of a roof survey. RICS’s own guidance flags this as a defect requiring further investigation, not a neutral “insulation choice” note.
It can change how your roof breathes. Foam can turn a traditional cold roof into a warm roof, altering ventilation and how moisture moves through the structure. Applied wrong, that traps damp against timber rather than letting it escape, leading to rot that is hidden exactly where the foam prevents anyone from seeing it.
Lenders have responded accordingly. A BBC investigation found that a quarter of the UK’s biggest mortgage providers will not lend against a home with spray foam in the roof at all. Reported positions include:
- Will not lend: TSB, Skipton Building Society, Co-operative Bank, Principality, and Aviva for equity release.
- Conditional, with a specialist report: Nationwide, Halifax, HSBC.
- Lean negative, case by case: Yorkshire Building Society and Metro Bank, reported as saying they would not usually lend where there is a significant amount of spray foam.
That list changes as lenders update policy, so treat it as an illustration of how split the market is, not a current checklist.
Removal usually costs more than installation did. Reported real-world cases include a £17,000 removal bill following a £12,000 original install. General removal estimates run to about £40 per square metre before disposal costs on top.
It is not only mortgages, insurance is affected too
Most coverage of this focuses on mortgages, but home insurance carries a related, separate risk worth knowing about even if you are not currently buying, selling, or remortgaging.
Many UK insurers now ask directly about spray foam during quotes or renewals. Reported responses range from a straightforward refusal to quote, through cover with roof-related claims specifically excluded, to standard cover with no issue at all, it genuinely varies by insurer. The underlying reason is the same one that worries lenders: with the timbers hidden, an insurer’s loss adjuster cannot assess whether roof damage is new or was there, unseen, before a claim.
You are generally required to disclose spray foam installation to your insurer. Not doing so is a form of non-disclosure that can, in the worst case, void a claim or the whole policy later, precisely when you need it most. If your loft already has spray foam, checking your current policy’s position on it is a five-minute job worth doing regardless of whether you are moving any time soon.
How to tell if a property already has it
If you are buying, or simply are not sure what a previous owner did to your own loft, spray foam is usually easy to spot without a specialist:
- Look in the loft. Genuine spray foam is unmistakable, a continuous, often yellowish or off-white, rigid or spongy coating directly on the underside of the roof, rather than the roll or loose material sitting flat on the floor between joists that most other insulation looks like.
- Check the EPC or any recent survey, since a previous energy assessment or homebuyer’s report will usually have noted it if the assessor could see it.
- Ask directly, and get it in writing, if you are buying, this is a standard and reasonable question to put to the seller through your conveyancer, given the real, documented mortgage and insurance implications above.
The alternative RICS itself points to
RICS’s own consumer guidance makes a more specific point than “they perform the same”: ordinary fibre insulation, laid to the recommended depth of around 300mm on the loft floor, can outperform spray foam applied at the thinner depths it is often installed at, at a fraction of the cost and with far less risk, because it does not touch the roof structure at all, and a surveyor can still see the timbers underneath it. The comparison depends on the depth actually installed on each side, so treat it as a strong steer, not a guarantee of equivalence. If your loft is a normal, accessible shape, floor-level insulation is very likely the better route. See our guide to loft insulation for the numbers.
Spray foam earns its keep mainly in genuinely awkward spaces, an oddly shaped roof void, a room-in-roof conversion, where floor-level insulation cannot reach and the alternative is no insulation at all.
If you already have it and need it removed
If a mortgage application, sale, or insurance renewal has brought you to this post because your loft already has spray foam, removal is a specialist job with a fairly predictable shape:
- A specialist survey first, to establish the foam type, how it was applied, and the true condition of the timbers underneath, since this determines both the removal method and whether any timber repair is also needed.
- Physical removal, by hand or with specialist tools, working section by section, disposal of the material, and a full clean of the roof void.
- A post-removal timber and roof-structure report, which is usually the actual document a lender or buyer’s surveyor wants to see, proof that the roof is now inspectable and in known condition, not just that the foam is gone.
- Timeline is typically a small number of days for a standard loft, longer if timber repairs are needed once the foam is off and the damage, if any, is actually visible for the first time.
Get quotes from removal specialists, not the original installer alone, and ask specifically whether the quote includes the post-removal report, since that is the document that actually unblocks a mortgage or sale, not the removal work by itself.
If you are set on it anyway
- Get an RICS-accredited survey first, not just an installer’s quote, specifically assessing whether your roof is a suitable candidate.
- Insist on documentation for a future sale or remortgage: a signed installer certificate, product data sheet, and evidence of building control sign-off if required. Buyers’ and your own future lenders’ surveyors will ask for this.
- Check it is not on a listed building or in a conservation area without separate consent, unauthorised work here has caused real legal problems for owners.
- Ask specifically what happens to your mortgage application if you try to remortgage or sell within the product’s lifetime, before you sign, not after.
The verdict
The bottom line: Spray foam genuinely insulates, but the mortgage and resale risk is real and well documented, not a rumour. For most straightforward lofts, 300mm of ordinary fibre insulation gets you close to the same thermal result without touching the roof structure, without the lending risk, and at a fraction of the cost. Reserve spray foam for the awkward spaces nothing else can reach, and only after an RICS-accredited survey confirms your roof is suitable.
Sources
- RICS, Spray foam insulation consumer guidance, published 31 March 2023. Checked 23 August 2026.
- HomeOwners Alliance, Spray foam insulation warning, citing BBC investigation and reported lender positions. Checked 23 August 2026.
Lender and insurer positions change over time and vary by product, application and provider; always check a specific lender or insurer’s current policy before proceeding, and treat this as general information, not advice on your mortgage, insurance or property. Reviewed by Adam, our editor. Every figure here is fact-checked against the sources listed above; see our editorial methodology, who we are, and our corrections policy if you spot something wrong.
Common questions
Can I get a mortgage on a house with spray foam?
Sometimes, but it is harder. A quarter of major lenders will not lend against it at all, and others require a specialist report first. If you are buying, factor in that your own future buyers will face the same hurdle.
Should I remove spray foam that is already there?
Not automatically. If it was well installed and documented, and you are not selling or remortgaging, you may leave it. But if it is causing damp, or you plan to sell, professional removal is often what unlocks a mortgage or insurance, for example a lender that refused may reconsider once a structural engineer certifies the cleared roof.
Is spray foam ever the right choice?
Occasionally, for genuinely awkward roof spaces that ordinary insulation cannot reach, and only after an RICS-accredited survey confirms suitability and you have the documentation for future buyers. For a normal, accessible loft, floor-level fibre insulation is the lower-risk answer.
Does it affect home insurance as well as mortgages?
Yes. Some insurers refuse cover or exclude roof claims, and you must disclose it, so check your policy’s position even if you are not moving.
